Age | Commit message (Collapse) | Author |
|
The tests in net/forwarding are generally expected to be HW-independent.
There are however several tests that, while not depending on any HW in
particular, nevertheless depend on being used on HW interfaces. Placing
these selftests to net/forwarding is confusing, because the selftest will
just report it can't be run on veth pairs. At the same time, placing them
to a particular driver's selftests subdirectory would be wrong.
Instead, add a new directory, drivers/net/hw, where these generic but HW
independent selftests should be placed. Move over several such tests
including one helper library.
Since typically these tests will not be expected to run, omit the directory
drivers/net/hw from the TARGETS list in selftests/Makefile. Retain a
Makefile in the new directory itself, so that a user can make -C into that
directory and act on those tests explicitly.
Cc: Roger Quadros <rogerq@kernel.org>
Cc: Tobias Waldekranz <tobias@waldekranz.com>
Cc: Danielle Ratson <danieller@nvidia.com>
Cc: Davide Caratti <dcaratti@redhat.com>
Cc: Johannes Nixdorf <jnixdorf-oss@avm.de>
Suggested-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Petr Machata <petrm@nvidia.com>
Link: https://lore.kernel.org/r/e11dae1f62703059e9fc2240004288ac7cc15756.1711464583.git.petrm@nvidia.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
Ethtool extended state cannot be tested with veth pairs, resulting in
failures:
# ./ethtool_extended_state.sh
TEST: Autoneg, No partner detected [FAIL]
Expected "Autoneg", got "Link detected: no"
[...]
Fix by skipping the test when used with veth pairs.
Fixes: 7d10bcce98cd ("selftests: forwarding: Add tests for ethtool extended state")
Reported-by: Mirsad Todorovac <mirsad.todorovac@alu.unizg.hr>
Closes: https://lore.kernel.org/netdev/adc5e40d-d040-a65e-eb26-edf47dac5b02@alu.unizg.hr/
Signed-off-by: Ido Schimmel <idosch@nvidia.com>
Reviewed-by: Petr Machata <petrm@nvidia.com>
Tested-by: Mirsad Todorovac <mirsad.todorovac@alu.unizg.hr>
Reviewed-by: Hangbin Liu <liuhangbin@gmail.com>
Acked-by: Nikolay Aleksandrov <razor@blackwall.org>
Link: https://lore.kernel.org/r/20230808141503.4060661-9-idosch@nvidia.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
Currently, this script sets up the test scenario, which is supposed to end
in an inability of the system to negotiate a link. It then waits for a bit,
and verifies that the system can diagnose why the link was not established.
The wait time for the scenario where different link speeds are forced on
the two ends of a loopback cable, was set to 4 seconds, which exactly
covered it. As of a recent mlxsw firmware update, this time gets longer,
and this test starts failing.
The time that selftests currently wait for links to be established is
currently $WAIT_TIMEOUT, or 20 seconds. It seems reasonable that if this is
the time necessary to establish and bring up a link, it should also be
enough to determine that a link cannot be established and why.
Therefore in this patch, convert the sleeps to busywaits, so that if a
failure is established sooner (as is expected), the test runs quicker. And
use $WAIT_TIMEOUT as the time to wait.
Signed-off-by: Petr Machata <petrm@nvidia.com>
Reviewed-by: Amit Cohen <amcohen@nvidia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
Add tests to check ethtool report about extended state.
The tests configure several states and verify that the correct extended
state is reported by ethtool.
Check extended state with substate (Autoneg) and extended state without
substate (No cable).
Signed-off-by: Amit Cohen <amitc@mellanox.com>
Reviewed-by: Petr Machata <petrm@mellanox.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
|