|
Add a codec driver for the Cirrus Logic CS48L32 audio DSP.
The CS48L32 is a low-power audio DSP with microphone inputs for
"Always on Voice" (i.e. voice trigger) and voice command processing.
It has a programmable Halo Core DSP and a variety of power-efficient
fixed-function audio processors, with configurable digital mixing
and routing.
There are two I2S/TDM audio serial ports.
Four analogue inputs are available through IN1. These feed into a
2-channel ADC through an analogue mux. There is an ALSA control for
each IN1 ADC channel to select which analogue input to use.
A dedicated digital mic (DMIC) PDM input is available on IN2.
Two PDM outputs can feed DMIC inputs on another codec or a host DMIC/PDM
input.
An on-board regulator provides a power supply or bias voltage to
attached microphones. Three switchable MICBIAS outputs are fed from this
allowing only the microphone in use to be powered-up. There are DAPM
widgets for these outputs: MICBIAS1A, MICBIAS1B and MICBIAS1C. The machine
driver must create a DAPM route from the required MICBIAS1x widget to the
INn input widgets to make the MICBIAS switch on when the audio input is
powered-up. For example if the microphone feeding CS48L32 pin IN1LN_1 is
powered from MICBIAS1A, the machine driver must create the path:
(sink) IN1LN_1 <----- (source) MICBIAS1A
Co-developed-by: Stuart Henderson <stuarth@opensource.cirrus.com>
Signed-off-by: Stuart Henderson <stuarth@opensource.cirrus.com>
Co-developed-by: Qi Zhou <qi.zhou@cirrus.com>
Signed-off-by: Qi Zhou <qi.zhou@cirrus.com>
Co-developed-by: Piotr Stankiewicz <piotrs@opensource.cirrus.com>
Signed-off-by: Piotr Stankiewicz <piotrs@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://patch.msgid.link/20250415115016.505777-3-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
