| Age | Commit message (Collapse) | Author |
|---|
|
Use the new helper as a step to deal with potential dst->dev races.
Signed-off-by: Eric Dumazet <edumazet@google.com>
Reviewed-by: Kuniyuki Iwashima <kuniyu@google.com>
Link: https://patch.msgid.link/20250630121934.3399505-9-edumazet@google.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
If the dst_entry is the same post transformation (which is a valid use
case for IOAM), we don't add it to the cache to avoid a reference loop.
Instead, we use a "fake" dst_entry and add it to the cache as a signal.
When we read the cache, we compare it with our "fake" dst_entry and
therefore detect if we're in the special case.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Link: https://patch.msgid.link/20250415112554.23823-3-justin.iurman@uliege.be
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
Be consistent and use the same terminology as other lwt users: orig_dst
is the dst_entry before the transformation, while dst is either the
dst_entry in the cache or the dst_entry after the transformation
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Link: https://patch.msgid.link/20250415112554.23823-2-justin.iurman@uliege.be
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
Fix the lwtunnel_output() reentry loop in ioam6_iptunnel when the
destination is the same after transformation. Note that a check on the
destination address was already performed, but it was not enough. This
is the example of a lwtunnel user taking care of loops without relying
only on the last resort detection offered by lwtunnel.
Fixes: 8cb3bf8bff3c ("ipv6: ioam: Add support for the ip6ip6 encapsulation")
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Link: https://patch.msgid.link/20250314120048.12569-3-justin.iurman@uliege.be
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
Some lwtunnels have a dst cache for post-transformation dst.
If the packet destination did not change we may end up recording
a reference to the lwtunnel in its own cache, and the lwtunnel
state will never be freed.
Discovered by the ioam6.sh test, kmemleak was recently fixed
to catch per-cpu memory leaks. I'm not sure if rpl and seg6
can actually hit this, but in principle I don't see why not.
Fixes: 8cb3bf8bff3c ("ipv6: ioam: Add support for the ip6ip6 encapsulation")
Fixes: 6c8702c60b88 ("ipv6: sr: add support for SRH encapsulation and injection with lwtunnels")
Fixes: a7a29f9c361f ("net: ipv6: add rpl sr tunnel")
Reviewed-by: Simon Horman <horms@kernel.org>
Link: https://patch.msgid.link/20250130031519.2716843-2-kuba@kernel.org
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
dst_cache_get() gives us a reference, we need to release it.
Discovered by the ioam6.sh test, kmemleak was recently fixed
to catch per-cpu memory leaks.
Fixes: 985ec6f5e623 ("net: ipv6: rpl_iptunnel: mitigate 2-realloc issue")
Fixes: 40475b63761a ("net: ipv6: seg6_iptunnel: mitigate 2-realloc issue")
Fixes: dce525185bc9 ("net: ipv6: ioam6_iptunnel: mitigate 2-realloc issue")
Reviewed-by: Justin Iurman <justin.iurman@uliege.be>
Reviewed-by: Simon Horman <horms@kernel.org>
Link: https://patch.msgid.link/20250130031519.2716843-1-kuba@kernel.org
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
This patch mitigates the two-reallocations issue with ioam6_iptunnel by
providing the dst_entry (in the cache) to the first call to
skb_cow_head(). As a result, the very first iteration may still trigger
two reallocations (i.e., empty cache), while next iterations would only
trigger a single reallocation.
Performance tests before/after applying this patch, which clearly shows
the improvement:
- inline mode:
- before: https://ibb.co/LhQ8V63
- after: https://ibb.co/x5YT2bS
- encap mode:
- before: https://ibb.co/3Cjm5m0
- after: https://ibb.co/TwpsxTC
- encap mode with tunsrc:
- before: https://ibb.co/Gpy9QPg
- after: https://ibb.co/PW1bZFT
This patch also fixes an incorrect behavior: after the insertion, the
second call to skb_cow_head() makes sure that the dev has enough
headroom in the skb for layer 2 and stuff. In that case, the "old"
dst_entry was used, which is now fixed. After discussing with Paolo, it
appears that both patches can be merged into a single one -this one-
(for the sake of readability) and target net-next.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
Most of the original conversion is from the spatch below,
but I edited some and left out other instances that were
either buggy after conversion (where default values don't
fit into the type) or just looked strange.
@@
expression attr, def;
expression val;
identifier fn =~ "^nla_get_.*";
fresh identifier dfn = fn ## "_default";
@@
(
-if (attr)
- val = fn(attr);
-else
- val = def;
+val = dfn(attr, def);
|
-if (!attr)
- val = def;
-else
- val = fn(attr);
+val = dfn(attr, def);
|
-if (!attr)
- return def;
-return fn(attr);
+return dfn(attr, def);
|
-attr ? fn(attr) : def
+dfn(attr, def)
|
-!attr ? def : fn(attr)
+dfn(attr, def)
)
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Reviewed-by: Toke Høiland-Jørgensen <toke@kernel.org>
Link: https://patch.msgid.link/20241108114145.0580b8684e7f.I740beeaa2f70ebfc19bfca1045a24d6151992790@changeid
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
This patch improves two checks on user data.
The first one prevents bit 23 from being set, as specified by RFC 9197
(Sec 4.4.1):
Bit 23 Reserved; MUST be set to zero upon transmission and be
ignored upon receipt. This bit is reserved to allow for
future extensions of the IOAM Trace-Type bit field.
The second one checks that the tunnel destination address !=
IPV6_ADDR_ANY, just like we already do for the tunnel source address.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Link: https://patch.msgid.link/20240830191919.51439-1-justin.iurman@uliege.be
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
This patch provides a new feature (i.e., "tunsrc") for the tunnel (i.e.,
"encap") mode of ioam6. Just like seg6 already does, except it is
attached to a route. The "tunsrc" is optional: when not provided (by
default), the automatic resolution is applied. Using "tunsrc" when
possible has a benefit: performance. See the comparison:
- before (= "encap" mode): https://ibb.co/bNCzvf7
- after (= "encap" mode with "tunsrc"): https://ibb.co/PT8L6yq
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
This patch prepares the next one by correcting the alignment of some
lines.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
As explained in commit 1378817486d6 ("tipc: block BH
before using dst_cache"), net/core/dst_cache.c
helpers need to be called with BH disabled.
Disabling preemption in ioam6_output() is not good enough,
because ioam6_output() is called from process context,
lwtunnel_output() only uses rcu_read_lock().
We might be interrupted by a softirq, re-enter ioam6_output()
and corrupt dst_cache data structures.
Fix the race by using local_bh_disable() instead of
preempt_disable().
Fixes: 8cb3bf8bff3c ("ipv6: ioam: Add support for the ip6ip6 encapsulation")
Signed-off-by: Eric Dumazet <edumazet@google.com>
Cc: Justin Iurman <justin.iurman@uliege.be>
Acked-by: Paolo Abeni <pabeni@redhat.com>
Link: https://lore.kernel.org/r/20240531132636.2637995-2-edumazet@google.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
struct nla_policy is usually constant itself, but unless
we make the ranges inside constant we won't be able to
make range structs const. The ranges are not modified
by the core.
Reviewed-by: Johannes Berg <johannes@sipsolutions.net>
Reviewed-by: David Ahern <dsahern@kernel.org>
Reviewed-by: Nikolay Aleksandrov <razor@blackwall.org>
Reviewed-by: Jiri Pirko <jiri@nvidia.com>
Link: https://lore.kernel.org/r/20231025162204.132528-1-kuba@kernel.org
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
Add support for the IOAM insertion frequency inside its lwtunnel output
function. This patch introduces a new (atomic) counter for packets,
based on which the algorithm will decide if IOAM should be added or not.
Default frequency is "1/1" (i.e., applied to all packets) for backward
compatibility. The iproute2 patch is ready and will be submitted as soon
as this one is accepted.
Previous iproute2 command:
ip -6 ro ad fc00::1/128 encap ioam6 [ mode ... ] ...
New iproute2 command:
ip -6 ro ad fc00::1/128 encap ioam6 [ freq k/n ] [ mode ... ] ...
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
tools/testing/selftests/net/ioam6.sh
7b1700e009cc ("selftests: net: modify IOAM tests for undef bits")
bf77b1400a56 ("selftests: net: Test for the IOAM encapsulation with IPv6")
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
The check for undefined bits in the trace type is moved from the input side to
the output side, while the input side is relaxed and now inserts default empty
values when an undefined bit is set.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
This patch adds support for the ip6ip6 encapsulation by providing three encap
modes: inline, encap and auto.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
This prerequisite patch provides some minor edits (alignments, renames) and a
minor modification inside a function to facilitate the next patch by using
existing nla_* functions.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
Add support for the IOAM inline insertion (only for the host-to-host use case)
which is per-route configured with lightweight tunnels. The target is iproute2
and the patch is ready. It will be posted as soon as this patchset is merged.
Here is an overview:
$ ip -6 ro ad fc00::1/128 encap ioam6 trace type 0x800000 ns 1 size 12 dev eth0
This example configures an IOAM Pre-allocated Trace option attached to the
fc00::1/128 prefix. The IOAM namespace (ns) is 1, the size of the pre-allocated
trace data block is 12 octets (size) and only the first IOAM data (bit 0:
hop_limit + node id) is included in the trace (type) represented as a bitfield.
The reason why the in-transit (IPv6-in-IPv6 encapsulation) use case is not
implemented is explained on the patchset cover.
Signed-off-by: Justin Iurman <justin.iurman@uliege.be>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
