| Age | Commit message (Collapse) | Author |
|---|
|
If the device is in secure mode it's unnecessary to send a SHUTDOWN and
SYSTEM_RESET around the firmware download. It could only be patching
insecure tunings. A tuning patch doesn't need a SHUTDOWN and only needs
a REINIT afterwards. This will reduce the overhead of exiting system
suspend in secure mode.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/Message-Id: <20230518150250.1121006-4-rf@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Rename the mixer source defines from CS35L56_INPUT_SRC_SWIRE_RXn
to CS35L56_INPUT_SRC_SWIRE_DP1_CHANNELn to match the latest
datasheet.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230418144309.1100721-5-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The mixer source index value for SDW2RX1 is different between
A1 and B0 silicon. As the driver doesn't provide a DAI for SDW2
just remove it as a mixer source option.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230418144309.1100721-4-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Reduce SDW1 to 4 channels and remove the controls for SDW1
TX5 and TX6.
The TX5 and TX6 channels have been removed from B0 silicon.
There is no need to support them on A1 silicon.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230418144309.1100721-3-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Check during cs35l56_system_resume() whether the firmware patch must
be applied again.
The FIRMWARE_MISSING flag in the PROTECTION_STATUS register indicates
whether the firmware has been patched.
In non-secure mode the FIRMWARE_MISSING flag is cleared at the end of
dsp_work(). If it is set after system-resume we know that dsp_work()
must be run again.
In secure mode the pre-OS loader will have done the secure patching
and cleared the FIRMWARE_MISSING flag. So this flag does not tell us
whether firmware memory was lost. But the driver could only be
downloading non-secure tunings, which is always safe to do.
If the driver has control of RESET we will have asserted it during
suspend so the firmware patch will have been lost. The driver would only
have control of RESET in non-secure mode.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/168122674550.26.8545058503709956172@mailman-core.alsa-project.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The CS35L56 combines a high-performance mono audio amplifier, Class-H
tracking inductive boost converter, Halo Core(TM) DSP and a DC-DC boost
converter supporting Class-H tracking.
Supported control interfaces are I2C, SPI or SoundWire.
Supported audio interfaces are I2S/TDM or SoundWire.
Most chip functionality is controlled by on-board ROM firmware that is
always running. The driver must apply patch/tune to the firmware
before using the CS35L56.
Signed-off-by: Simon Trimmer <simont@opensource.cirrus.com>
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20230320112245.115720-9-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
