| Age | Commit message (Collapse) | Author |
|---|
|
As the first frame in "repeat-mode" is the pattern, the pattern done
interrupt is ignored by the driver. With small resolution bitstreams,
the interrupts might fire too quickly and hardware combine two irqs to
once because irq handle have latency. Thus the driver might miss the
frame decode done interrupt from the first actual frame.
In order to avoid the driver wait for the frame done interrupt that has
been combined to the pattern done interrupt and been ignored, driver
will check the curr_desc and slot_status registers to figure out if the
decoding of actual frame is finished or not.
Firstly we check the curr_desc register,
- if it is still pointing to the pattern descriptor, the second actual
frame is not started, we can wait for its frame-done interrupt.
- if the curr_desc has pointed to the frame descriptor, then we check the
ongoing bit of slot_status register.
- if the ongoing bit is set to 1, the decoding of the actual frame is not
finished, we can wait for its frame-done interrupt.
- if the ongoing bit is set to 0, the decoding of the actual frame is
finished, we can't wait for the second interrupt, but mark it as done.
But there is still a small problem, that the curr_desc and slot_status
registers are not synchronous. curr_desc is updated when the
next_descpt_ptr is loaded, but the ongoing bit of slot_status is set
after the 32 bytes descriptor is loaded, there will be a short time
interval in between, which may cause fake false. Consider read register
is quite slow compared with IP read 32byte from memory, read twice
slot_status can avoid this situation.
Signed-off-by: Ming Qian <ming.qian@oss.nxp.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Signed-off-by: Nicolas Dufresne <nicolas.dufresne@collabora.com>
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
|
|
These are never implemented, remove them.
Signed-off-by: Yue Haibing <yuehaibing@huawei.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
|
|
imx jpeg encoder and decoder support 4 slots each,
aim to support some virtualization scenarios.
driver should only enable one slot one time.
but due to some hardware issue,
only slot 0 can be enabled in imx8q platform,
and they may be fixed in imx9 platform.
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
enable encoding 12-bit extended jpeg
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
clear slot next desc ptr if config error,
otherwise codec will report config error interrupt repeatedly,
it may led to system hang.
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
The interrupt STMBUF_HALF may be triggered after frame done.
It may led to system hang if driver try to access the register after
power off.
Disable the slot interrupt when frame done.
Fixes: 2db16c6ed72ce ("media: imx-jpeg: Add V4L2 driver for i.MX8 JPEG Encoder/Decoder")
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Reviewed-by: Mirela Rabulea <mirela.rabulea@nxp.com>
Tested-by: Mirela Rabulea <mirela.rabulea@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
the register CAST_NOMFRSIZE_LO should be equal to CAST_STATUS16
the register CAST_NOMFRSIZE_HI should be equal to CAST_STATUS17
the register CAST_OFBSIZE_LO should be equal to CAST_STATUS18
the register CAST_OFBSIZE_HI should be equal to CAST_STATUS19
Fixes: 2db16c6ed72ce ("media: imx-jpeg: Add V4L2 driver for i.MX8 JPEG Encoder/Decoder")
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Reviewed-by: Mirela Rabulea <mirela.rabulea@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
Implement V4L2_CID_JPEG_COMPRESSION_QUALITY
to set jpeg quality
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
The hardware is capable of encoding/decoding RGB and ARGB formats
in whatever order the color components are,
but the resulting jpegs look good
if we start with raw data in BGR/ABGR order,
so we will further only support V4L2_PIX_FMT_BGR24 and V4L2_PIX_FMT_ABGR32.
Signed-off-by: Ming Qian <ming.qian@nxp.com>
Reviewed-by: Mirela Rabulea <mirela.rabulea@nxp.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
|
In order to cleanup the main platform media directory, move NXP
drivers to their own directory.
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
|
