Merge tag 'mtd/for-6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux

Pull mtd updates from Miquel Raynal:
 "MTD changes:

   - Apart from a binding conversion to yaml, only minor changes/small
     fixes have been merged.

  Raw NAND changes:

   - Minor fixes for various controller drivers like DMA mapping checks,
     better timing derivations or bitflip statistics.

   - some Hynix NAND flashes were not supporting read-retries, so don't
     even try to do it

  SPI NAND changes:

   - In order to support high-speed modes, certain chips need extra
     configuration like adding more dummy cycles. This is now possible,
     especially on Winbond chips.

   - Aside from that, Gigadevice gets support for a new chip (GD5F1GM9).

  SPI NOR changes:

   - A notable changes is the fix for exiting 4-byte addressing on
     Infineon SEMPER flashes. These flashes do not support the standard
     EX4B opcode (E9h), and use a vendor-specific opcode (B8h) instead.

   - There is also a fix for unlocking flashes that are write-protected
     at power-on. This was caused by using an uninitialized mtd_info in
     spi_nor_try_unlock_all()"

* tag 'mtd/for-6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux: (26 commits)
  mtd: spinand: winbond: Add comment about the maximum frequency
  mtd: spinand: winbond: Enable high-speed modes on w35n0xjw
  mtd: spinand: winbond: Enable high-speed modes on w25n0xjw
  mtd: spinand: Add a ->configure_chip() hook
  mtd: spinand: Add a frequency field to all READ_FROM_CACHE variants
  mtd: spinand: Fix macro alignment
  spi: spi-mem: Take into account the actual maximum frequency
  spi: spi-mem: Use picoseconds for calculating the op durations
  mtd: rawnand: atmel: set pmecc data setup time
  mtd: spinand: propagate spinand_wait() errors from spinand_write_page()
  mtd: rawnand: fsmc: Add missing check after DMA map
  mtd: rawnand: rockchip: Add missing check after DMA map
  mtd: rawnand: hynix: don't try read-retry on SLC NANDs
  mtd: rawnand: atmel: Fix dma_mapping_error() address
  mtd: nand: brcmnand: fix mtd corrected bits stat
  mtd: rawnand: renesas: Add missing check after DMA map
  mtd: spinand: gigadevice: Add support for GD5F1GM9 chips
  mtd: nand: brcmnand: replace manual string choices with standard helpers
  mtd: map: Don't use "proxy" headers
  mtd: spi-nor: Fix spi_nor_try_unlock_all()
  ...

1 files changed, 6 insertions, 0 deletions

diff --git a/drivers/mtd/nand/raw/atmel/pmecc.c b/drivers/mtd/nand/raw/atmel/pmecc.c
index 3c7dee1be21df..0b402823b619c 100644
--- a/drivers/mtd/nand/raw/atmel/pmecc.c
+++ b/drivers/mtd/nand/raw/atmel/pmecc.c
@@ -143,6 +143,7 @@ struct atmel_pmecc_caps {
 	int nstrengths;
 	int el_offset;
 	bool correct_erased_chunks;
+	bool clk_ctrl;
 };
 
 struct atmel_pmecc {
@@ -843,6 +844,10 @@ static struct atmel_pmecc *atmel_pmecc_create(struct platform_device *pdev,
 	if (IS_ERR(pmecc->regs.errloc))
 		return ERR_CAST(pmecc->regs.errloc);
 
+	/* pmecc data setup time */
+	if (caps->clk_ctrl)
+		writel(PMECC_CLK_133MHZ, pmecc->regs.base + ATMEL_PMECC_CLK);
+
 	/* Disable all interrupts before registering the PMECC handler. */
 	writel(0xffffffff, pmecc->regs.base + ATMEL_PMECC_IDR);
 	atmel_pmecc_reset(pmecc);
@@ -896,6 +901,7 @@ static struct atmel_pmecc_caps at91sam9g45_caps = {
 	.strengths = atmel_pmecc_strengths,
 	.nstrengths = 5,
 	.el_offset = 0x8c,
+	.clk_ctrl = true,
 };
 
 static struct atmel_pmecc_caps sama5d4_caps = {