| Age | Commit message (Collapse) | Author |
|---|
|
The GSI general interrupt is managed by three registers: enable;
status; and clear. The three registers have same set of field bits
at the same locations. Use a common set of field masks for all
three registers to avoid duplication.
Signed-off-by: Alex Elder <elder@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
The GSI global interrupt is managed by three registers: enable;
status; and clear. The three registers have same set of field bits
at the same locations. Use a common set of field masks for all
three registers to avoid duplication.
Signed-off-by: Alex Elder <elder@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
The GSI interrupt type register and interrupt type mask register
have the same field bits at the same locations. Use a common set of
field masks for both registers rather than essentially duplicating
them. The only place the interrupt mask register uses any of these
is in gsi_irq_enable().
Signed-off-by: Alex Elder <elder@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
Zero the result code stored in a field of the scratch 0 register
before issuing a generic EE command. This just guarantees that
the value we read later was actually written as a result of the
command.
Also add the definitions of two more possible result codes that can
be returned when issuing flow control enable or disable commands:
INCORRECT_CHANNEL_STATE: - channel must be in started state
INCORRECT_DIRECTION - flow control is only valid for TX channels
Signed-off-by: Alex Elder <elder@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
The Generic Software Interface is a layer of the IPA driver that
abstracts the underlying hardware. The next patch includes the
main code for GSI (including some additional documentation). This
patch just includes three GSI header files.
- "gsi.h" is the top-level GSI header file. This structure is
is embedded within the IPA structure. The main abstraction
implemented by the GSI code is the channel, and this header
exposes several operations that can be performed on a GSI channel.
- "gsi_private.h" exposes some definitions that are intended to be
private, used only by the main GSI code and the GSI transaction
code (defined in an upcoming patch).
- Like "ipa_reg.h", "gsi_reg.h" defines the offsets of the 32-bit
registers used by the GSI layer, along with masks that define the
position and width of fields less than 32 bits located within
these registers.
Signed-off-by: Alex Elder <elder@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
|
