summaryrefslogtreecommitdiff
path: root/drivers/net/ethernet/intel/e1000e/hw.h
AgeCommit message (Collapse)Author
2012-05-02e1000e: fix .ndo_set_rx_mode for 82579Bruce Allan
Secondary unicast and multicast addresses are added to the Receive Address registers (RAR) for most parts supported by the driver. For 82579, there is only one actual RAR and a number of Shared Receive Address registers (SHRAR) that are shared among the driver and f/w which can be reserved and write-protected by the f/w. On this device, use the SHRARs that are not taken by f/w for the additional addresses. Add a MAC ops function pointer infrastructure (similar to other MAC operations in the driver) for setting RARs, introduce a new rar_set function for 82579 and convert the existing code that sets RARs on other devices to a generic rar_set function. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-05-02e1000e: workaround EEPROM configuration change on 82579Bruce Allan
An update to the EEPROM on 82579 will extend a delay in hardware to fix an issue with WoL not working after a G3->S5 transition which is unrelated to the driver. However, this extended delay conflicts with nominal operation of the device when it is initialized by the driver and after every reset of the hardware (i.e. the driver starts configuring the device before the hardware is done with it's own configuration work). The workaround for when the driver is in control of the device is to tell the hardware after every reset the configuration delay should be the original shorter one. Some pre-existing variables are renamed generically to be re-used with new register accesses. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-04-27e1000e: 82579 potential system hang on stress when ME enabledBruce Allan
Previously, a workaround was added to address a hardware bug in the PCIm2PCI arbiter where a write by the driver of the Transmit/Receive Descriptor Tail register could happen concurrently with a write of any MAC CSR register by the Manageability Engine (ME) which could cause the Tail register to have an incorrect value. The arbiter is supposed to prevent the concurrent writes but there is a bug that can cause the Host (driver) access to be acknowledged later than it should. After further investigation, it was discovered that a driver write access of any MAC CSR register after being idle for some time can be lost when ME is accessing a MAC CSR register. When this happens, no further target access is claimed by the MAC which could hang the system. The workaround to check bit 24 in the FWSM register (set only when ME is accessing a MAC CSR register) and delay for a limited amount of time until it is cleared is now done for all driver writes of MAC CSR registers on 82579 with ME enabled. In the rare case when the driver is writing the Tail register and ME is accessing any MAC CSR register for a duration longer than the maximum delay, write the register and verify it has the correct value before continuing, otherwise reset the device. This patch also moves some pre-existing macros from the hardware-specific header file to the more appropriate generic driver header file. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-04-04e1000e: cleanup indexed register arraysBruce Allan
Some Rx and Tx specific registers are arrays indexed by the queue number. For clarity, specify the intended queue rather than obscuring it behind a define. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Aaron Brown <aaron.f.brown@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-02-24e1000e: rename e1000e_reload_nvm() and call as function pointerBruce Allan
Rename e1000e_reload_nvm() to e1000e_reload_nvm_generic() to signify the function is used for more than one MAC-family type, and set and use it as a MAC ops function pointer to be consistent with the driver design. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Aaron Brown <aaron.f.brown@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-02-24e1000e: rename e1000e_config_collision_dist() and call as function pointerBruce Allan
Rename e1000e_config_collision_dist() to e1000e_config_collision_dist_generic() to signify the function is used for more than one MAC-family type, and set and use it as a MAC ops function pointer to be consistent with the driver design. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Aaron Brown <aaron.f.brown@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-01-26e1000e: update copyright yearBruce Allan
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Aaron Brown <aaron.f.brown@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-01-25e1000e: convert head, tail and itr_register offsets to __iomem pointersBruce Allan
The Tx/Rx head and tail registers and itr_register are always at known addresses based on the __iomem address at which the PCI region (from BAR 0) is mapped and known offsets within the region for each of these registers. Store and use the full address rather than just the region offset to reduce unnecessary address calculations. Also, change current u8 __iomem pointers to void __iomem pointers. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Aaron Brown <aaron.f.brown@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2012-01-25e1000e: add Receive Packet Steering (RPS) supportBruce Allan
Enable RPS by default. Disallow jumbo frames when both receive checksum and receive hashing are enabled because the hardware cannot do both IP payload checksum (enabled when receive checksum is enabled when using packet split which is used for jumbo frames) and provide RSS hash at the same time. v2: added ethtool command to query flow hashing behavior per Ben Hutchings and changed the type of rsskey to cleanup the setting of the register array and avoid unnecessary casts (as pointed out by Joe Perches). The long error messages are not changed since there is nothing in the kernel ./Documentation that suggests the preferred method for dealing with long messages other than to never break strings; leaving them as-is for now. Signed-off-by: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
2011-08-10intel: Move the Intel wired LAN driversJeff Kirsher
Moves the Intel wired LAN drivers into drivers/net/ethernet/intel/ and the necessary Kconfig and Makefile changes. Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>