summaryrefslogtreecommitdiff
path: root/drivers/net/ethernet/atheros/atl1c
AgeCommit message (Collapse)Author
2012-04-18atl1c: using fixed TXQ configuration for l2cb and l1cHuang, Xiong
using fixed TXQ config for l2cb and l1c regardless dmar_block to make tx-DMA more stable. register REG_TXQ_CTRL is refined as well. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: remove dmaw_blockHuang, Xiong
dmaw_block is never used in the driver, remove it. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: correct wrong definition of REG_DMA_CTRLHuang, Xiong
some fields of REG_DMA_CTRL(15C0) are wrong, replace with the newest one. haredware uses fixed dma-write-block size, remove dmaw_block related code in function atl1c_configure_dma. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: wrong register used to stop TXQHuang, Xiong
function atl1c_stop_mac uses wrong register of REG_TWSI_CTRL to stop mac, replace it with REG_TXQ_CTRL. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: remove code related to rxq 1/2/3Huang, Xiong
remove code related to rxq 1/2/3 since multi-q not support. refine REG_RXQ_CTRL definition as well. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: split 2 32bit registers of TPD to 4 16bit registersHuang, Xiong
TPD producer/consumer index is 16bit wide. 16bit read/write reduce the dependency of the 2 tpd rings (hi and lo) rename reg(157C/1580) to keep name coninsistency. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: remove SMB/CMB DMA related codeHuang, Xiong
l1c & later chips don't support DMA for SMB. CMB is removed from hardware. reg(15C8) is used to trig interrupt by tpd threshold. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: remove VPD registerHuang, Xiong
VPD register is only used for L1(devid=PCI_DEVICE_ID_ATTANSIC_L1) to access external NV-memory. l1c & later chip doesn't use it any more. PHY 0/1 registers occupy the last 2 slots of the dump table. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: remove HDS registerHuang, Xiong
remove HDS register as it doesn't exist in hardware. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: remove multiple-RX-Q codeHuang, Xiong
the multiple-RX-Q in hardware doesn't work, all related register definition & code are removed. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-18atl1c: update author contact info & company/driver desciptionHuang, Xiong
replace unavailable email of the author since he left with a mail-list. update company info as well, Atheros was acquired by Qualcomm. insert "100" to driver description since it support 100M controller. Signed-off-by: xiong <xiong@qca.qualcomm.com> Tested-by: Liu David <dwliu@qca.qualcomm.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-07atl1c: stop using net_device.{base_addr, irq}.Francois Romieu
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Cc: Jay Cliburn <jcliburn@gmail.com> Cc: Chris Snook <chris.snook@gmail.com>
2012-03-09Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/netDavid S. Miller
2012-03-08atl1c: set ATL1C_WORK_EVENT_RESET bit correctlyDan Carpenter
ATL1C_WORK_EVENT_RESET is zero so the original code here is a nop. The intent was to set the zero bit. Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-02-26Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/netDavid S. Miller
Conflicts: drivers/net/ethernet/sfc/rx.c Overlapping changes in drivers/net/ethernet/sfc/rx.c, one to change the rx_buf->is_page boolean into a set of u16 flags, and another to adjust how ->ip_summed is initialized. Signed-off-by: David S. Miller <davem@davemloft.net>
2012-02-19atl1c: dont use highprio tx queueEric Dumazet
This driver attempts to use two TX rings but lacks proper support : 1) IRQ handler only takes care of TX completion on first TX ring 2) the stop/start logic uses the legacy functions (for non multiqueue drivers) This means all packets witk skb mark set to 1 are sent through high queue but are never cleaned and queue eventualy fills and block the device, triggering the infamous "NETDEV WATCHDOG" message. Lets use a single TX ring to fix the problem, this driver is not a real multiqueue one yet. Minimal fix for stable kernels. Reported-by: Thomas Meyer <thomas@m3y3r.de> Tested-by: Thomas Meyer <thomas@m3y3r.de> Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com> Cc: Jay Cliburn <jcliburn@gmail.com> Cc: Chris Snook <chris.snook@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-02-17atheros eth: set addr_assign_type if random_ether_addr() usedDanny Kukawka
Set addr_assign_type correctly to NET_ADDR_RANDOM in case a random MAC address was generated and assigned to the netdevice. Fix error handling in atl1c_probe(). If atl1c_read_mac_addr() couldn't get the hw mac address, and a random mac address get set return the error code. Don't go to err_eeprom in atl1c_probe(), use the generated MAC address in this case. Reset the state to NET_ADDR_PERM as soon as the MAC get changed via .ndo_set_mac_address. v2: use bitops Signed-off-by: Danny Kukawka <danny.kukawka@bisect.de> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-02-06netdev: ethernet dev_alloc_skb to netdev_alloc_skbPradeep A Dalvi
Replaced deprecating dev_alloc_skb with netdev_alloc_skb in drivers/net/ethernet - Removed extra skb->dev = dev after netdev_alloc_skb Signed-off-by: Pradeep A Dalvi <netdev@pradeepdalvi.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-01-31drivers/net: Remove alloc_etherdev error messagesJoe Perches
alloc_etherdev has a generic OOM/unable to alloc message. Remove the duplicative messages after alloc_etherdev calls. Signed-off-by: Joe Perches <joe@perches.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-11-22Sweep away N/A fw_version dustbunnies from the .get_drvinfo routine of a ↵Rick Jones
number of drivers Per discussion with Ben Hutchings and David Miller, go through and remove assignments of "N/A" to fw_version in various drivers' .get_drvinfo routines. While there clean-up some use of bare constants and such. Signed-off-by: Rick Jones <rick.jones2@hp.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-11-16net: introduce and use netdev_features_t for device features setsMichał Mirosław
v2: add couple missing conversions in drivers split unexporting netdev_fix_features() implemented %pNF convert sock::sk_route_(no?)caps Signed-off-by: Michał Mirosław <mirq-linux@rere.qmqm.pl> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-10-19net: add skb frag size accessorsEric Dumazet
To ease skb->truesize sanitization, its better to be able to localize all references to skb frags size. Define accessors : skb_frag_size() to fetch frag size, and skb_frag_size_{set|add|sub}() to manipulate it. Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-10-06net: use DMA_x_DEVICE and dma_mapping_error with skb_frag_dma_mapIan Campbell
When I converted some drivers from pci_map_page to skb_frag_dma_map I neglected to convert PCI_DMA_xDEVICE into DMA_x_DEVICE and pci_dma_mapping_error into dma_mapping_error. Signed-off-by: Ian Campbell <ian.campbell@citrix.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-08-30atl1c: convert to SKB paged frag API.Ian Campbell
Signed-off-by: Ian Campbell <ian.campbell@citrix.com> Cc: Jay Cliburn <jcliburn@gmail.com> Cc: Chris Snook <chris.snook@gmail.com> Cc: Jie Yang <jie.yang@atheros.com> Cc: netdev@vger.kernel.org Signed-off-by: David S. Miller <davem@davemloft.net>
2011-08-17net: remove use of ndo_set_multicast_list in driversJiri Pirko
replace it by ndo_set_rx_mode Signed-off-by: Jiri Pirko <jpirko@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-08-11atl*: Move the Atheros driversJeff Kirsher
Move the Atheros drivers into drivers/net/ethernet/atheros/ and make the necessary Kconfig and Makefile changes. CC: Jay Cliburn <jcliburn@gmail.com> CC: Chris Snook <chris.snook@gmail.com> CC: Jie Yang <jie.yang@atheros.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
generated by cgit v1.2.3 (git 2.39.1) at 2025-08-03 12:45:56 +0000