summaryrefslogtreecommitdiff
path: root/drivers/mmc/core
AgeCommit message (Expand)Author
2016-12-05mmc: queue: Fix queue thread wake-upAdrian Hunter
2016-11-29mmc: delete is_first_req parameter from pre-request callbackLinus Walleij
2016-11-29mmc: core: Update CMD13 polling policy when switch to HS DDR modeUlf Hansson
2016-11-29mmc: core: Allow CMD13 polling when switching to HS mode for mmcUlf Hansson
2016-11-29mmc: core: Enable __mmc_switch() to change bus speed timing for the hostUlf Hansson
2016-11-29mmc: core: Check SWITCH_ERROR bit from each CMD13 response when pollingUlf Hansson
2016-11-29mmc: core: Rename ignore_crc to retry_crc_err to reflect its purposeUlf Hansson
2016-11-29mmc: core: Remove redundant __mmc_send_status()Ulf Hansson
2016-11-29mmc: core: Retry instead of ignore at CRC errors when polling for busyUlf Hansson
2016-11-29mmc: core: use enum mmc_blk_status properlyLinus Walleij
2016-11-29mmc: core: Don't power off the card when starting the hostUlf Hansson
2016-11-29mmc: core: expose the capability of gpio card detectShawn Lin
2016-11-29mmc: core: Don't use ->card_busy() and CMD13 in combination when pollingUlf Hansson
2016-11-29mmc: core: Factor out code related to polling in __mmc_switch()Ulf Hansson
2016-11-29mmc: core: Clarify code which deals with polling in __mmc_switch()Ulf Hansson
2016-11-29mmc: core: Make mmc_switch_status() available for mmc coreUlf Hansson
2016-11-07mmc: mmc: Use 500ms as the default generic CMD6 timeoutUlf Hansson
2016-10-10mmc: core: changes frequency to hs_max_dtr when selecting hs400esShawn Lin
2016-10-10mmc: core: switch to 1V8 or 1V2 for hs400es modeShawn Lin
2016-09-26mmc: core: don't try to switch block size for dual rate modeZiyuan Xu
2016-09-26mmc: core: Add support for sending commands during data transferAdrian Hunter
2016-09-26mmc: core: Optimize the mmc erase size alignmentBaolin Wang
2016-09-26mmc: core: Factor out the alignment of erase sizeBaolin Wang
2016-09-26mmc: core: Use a default maximum erase timeoutUlf Hansson
2016-09-26mmc: sdio: deploy error handling instead of triggering BUG_ONShawn Lin
2016-09-26mmc: core: Add error message when switching fails in mmc_select_hs()Jungseung Lee
2016-09-26mmc: sd: Export SD Status via “ssr” device attributeUri Yanai
2016-09-26mmc: pwrseq-simple: Add an optional post-power-on-delayHans de Goede
2016-07-25mmc: Change the max discard sectors and erase response when HW busy detectBaolin Wang
2016-07-25mmc: core: Extend sysfs with DSR registerBojan Prtvar
2016-07-25mmc: core: expose MMC_CAP2_NO_* to dtShawn Lin
2016-07-25mmc: core: Extend sysfs with OCR registerBojan Prtvar
2016-07-25mmc: core: Allow hosts to specify non-support for MMC commandsShawn Lin
2016-07-25mmc: core: Allow hosts to specify non-support for SD commandsUlf Hansson
2016-07-25mmc: core: Disable HPI for certain Hynix eMMC cardsPratibhasagar V
2016-07-25mmc: core: Only change mode if mmc_select_bus_width() is successfulPeter Griffin
2016-07-25mmc: Set pref erase size based on sizeGwendal Grignou
2016-07-25mmc: mmc: Fix HS switch failure in mmc_select_hs400()Ziyuan Xu
2016-07-25mmc: mmc: fix switch timeout issue caused by jiffies precisionChaotian Jing
2016-07-25mmc: mmc: do not use CMD13 to get status after speed mode switchChaotian Jing
2016-07-25mmc: mmc: Use ->card_busy() to detect busy cards in __mmc_switch()Chaotian Jing
2016-07-25mmc: debugfs: add HS400 enhanced strobe descriptionShawn Lin
2016-07-25mmc: core: implement enhanced strobe supportShawn Lin
2016-07-25mmc: core: add mmc-hs400-enhanced-strobe supportShawn Lin
2016-06-02mmc: fix mmc mode selection for HS-DDR and higherChen-Yu Tsai
2016-05-27remove lots of IS_ERR_VALUE abusesArnd Bergmann
2016-05-23mmc: longer timeout for long read time quirkMatt Gumbel
2016-05-17mmc: core: Add a facility to "pause" re-tuningAdrian Hunter
2016-05-16mmc: mmc: Fix partition switch timeout for some eMMCsAdrian Hunter
2016-05-16mmc: sdio: fall back to SDIO 1.0 for broken 1.1 cardsWolfram Sang
generated by cgit v1.2.3 (git 2.39.1) at 2025-08-02 22:24:16 +0000