| Age | Commit message (Collapse) | Author |
|---|
|
I'm going to hook vc4 up to the sphinx build, so clean up its comments
to not generate warnings when we do.
Signed-off-by: Eric Anholt <eric@anholt.net>
Acked-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Link: http://patchwork.freedesktop.org/patch/msgid/20170227201144.10970-2-eric@anholt.net
|
|
If dsi_connector fails to allocate, the exit path via label 'fail'
checks if connector is null, which it always is, so the cleanup
that destroys connector is never going to be called. Hence the
failure path can be more optimally performed by removing this
and just returning ERR_PTR(-ENOMEM). This also removes the need
to initialize connector to NULL, and we can also remove ret too.
Detected by CoverityScan, CID#1399504 ("Logicall Dead Code")
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Reviewed-by: Eric Anholt <eric@anholt.net>
Reviewed-by: Gustavo Padovan <gustavo.padovan@collabora.com>
Link: http://patchwork.freedesktop.org/patch/msgid/20170203195624.7189-1-colin.king@canonical.com
|
|
The DSI0 and DSI1 blocks on the 2835 are related hardware blocks.
Some registers move around, and the featureset is slightly different,
as DSI1 (the 4-lane DSI) is a later version of the hardware block.
This driver doesn't yet enable DSI0, since we don't have any hardware
to test against, but it does put a lot of the register definitions and
code in place.
v2: Use the clk_hw interfaces, don't set CLK_IS_BASIC (from review by
Stephen Boyd)
Signed-off-by: Eric Anholt <eric@anholt.net>
Acked-by: Daniel Vetter <daniel.vetter@ffwll.ch> (v1)
Link: http://patchwork.freedesktop.org/patch/msgid/20170131192912.11316-1-eric@anholt.net
|
